Optimized method for measuring of positron annihilation lifetime spectra in nanomaterials with extended porosity for sensor applications
Оптимізований метод вимірювання позитронних анігіляційних спектрів у наноматеріалах з розвиненою поруватістю для сенсорних застосувань
Halyna Klym, Yuriy Kostiv, Dmytro Chalyy, Andriy Ivanusa, Taras Tkachuk
2016
Measuring Equipment and Metrology
1 Національний університет "Львівська політехніка", вул. С. Бандери, 12, 79013, Львів, Україна 2 Львівський державний університет безпеки життєдіяльності, вул. Клепарівська, 35, 79000, Львів, Україна Запропоновано та використано оптимізований за апаратною складністю метод вимірювання позитронних анігіляційних спектрів для дослідження вологочутливої кераміки MgО-Al 2 O 3 з розвиненою нанопоруватістю. Показано, що в разі розкладу спектрів на чотири компоненти вдається оцінити розміри нанопор за
more »
... деллю Тао-Ельдрупа та вивчити процеси, які відбуваються в них. Встановлено, що частка нанопор радіусом ~1,5 нм на порядок перевищує частку пор з радіусом ~ 0,3 нм, в яких також відбувається анігіляція ортопозитронію у адсорбованій воді. Ключові слова: позитронна анігіляційна спектроскопія, метод дослідження структури, сенсорна кераміка, нанопори, адсорбція. Предложен и использован оптимизированный за аппаратной сложностью метод измерения позитронных аннигиляционных спектров для исследования влагочувствительной керамики MgО-Al 2 O 3 с развитой нанопористостью. Показано, что при разложении спектров на четыре компоненты удается оценить размеры нанопор по модели Тао-Ельдрупа и изучить процессы, происходящие в них. Установлено, что доля нанопор радиусом ~ 1,5 нм на порядок превышает долю пор с радиусом ~ 0,3 нм, в которых также происходит аннигиляция ортопозитрония в адсорбированной влаге. Ключевые слова: позитронная аннигиляционная спектроскопия, метод исследования структуры, сенсорная керамика, нанопоры, адсорбция. An optimized by hardware complexity method for measuring of positron annihilation lifetime spectra was proposed and used to investigation of humidity-sensitive MgO-Al 2 O 3 ceramics with advanced nanoporosity. Positron-positronium annihilation spectrum were analyzed using four-component fitting procedures. It is shown that this technique can be used to investigation of nanopores transformation in humidity-sensitive MgO-Al 2 O 3 ceramics as porosimetry method. It is shown that Tao-Eldrup model can be used for study of size of nanopores smaller then 1,5 nm. It has been shown that for MgO-Al 2 O 3 ceramics two positron annihilation channels should be considered -the positron trapping with shortest τ 1 and middle τ 2 lifetimes and ortho-positronium decaying with the longest τ 3 and τ 4 lifetimes, these channels being independent ones. Assuming the two-state positron trapping model for spinel ceramics, four components in the fit of the experimental spectra can be associated with the microstructure peculiarities of the spinel. This microstructure exhibits characteristic octahedral and tetrahedral cation vacancies (τ 1 , I 1 ), positron trapping extended defects located near grain boundaries and positron traps in the free-volume entities (τ 2 , I 2 ). Ortho-positronium decay in nanopores of ceramics is described by τ 3 , I 3 and τ 4 , I 4 . Within the formalism of this model, the open volume entities free of the electron density are treated as defects, while hypothetical structure without these entities is treated as the defect-free bulk. It is established that the third component of lifetime spectra gives information about ortho-positronium decaying in nanopores with water and fourth component reflects ortho-positronium trapping in free-water volume of nanopores. It is established that in inner structure ceramic materials there are two types of nanopores. The intensity of the third component of the spectrum increases in water-filled samples, while the intensity of four components -decreases. The most significant changes caused by water adsorption processes are observed in largest nanopores with radius of ~1,7 nm. Reducing the value of the lifetime τ 4 after drying of ceramics can be due to the formation of thin layers of Lviv Polytechnic National University Institutional Repository http://ena.lp.edu.ua Вимірювальна техніка та метрологія, № 77, 2016 р.
doi:10.23939/istcmtm2016.77.087
fatcat:snsfbb57xjcnrfkegbkkzwqp4y