Mechanical test results on Dipole model C-1 25 mm aluminum collars [report]

C. Peters
1985 unpublished
Introduction This report is a summary of procedures used in collaring the SSC Dipole model C-1. Included are descriptions of the collars, instrumentation, collar pack preparation, collaring procedures, and colic? dimension and coil pressure data measurements taken during collaring and testing of the magnet. Collars Individual collar plates are machined from 0*125 inch thick 7075 -T6 aluminum alloy plate. Fabrication included N.C. machining and EDM. Figure 1 shows the basic collar dimensions.
more » ... iew of Mechanical Tests A series of mechanical load deflection tests were formerly completed and are summarized in Table I . Tests were conducted with a stack of collars pinned and keyed together. A more complete description is given in 5SC-MAG Note #25.
doi:10.2172/5224978 fatcat:jdqkrsnexrajtmx7xgjz2lt35u