A new Dobson Umkehr ozone profile retrieval method optimising information content and resolution

K. Stone, M. B. Tully, S. K. Rhodes, R. Schofield
2014 Atmospheric Measurement Techniques Discussions  
The standard Dobson Umkehr methodology to retrieve coarse resolution ozone profiles used by the National Oceanographic and Atmospheric Administration uses designated solar zenith angles (SZA). However, some information may be lost if measurements lie outside the designated SZA range (between 60 and 90°), or do not conform to the fitting technique. Also, while Umkehr measurements can be taken using multiple wavelength pairs (A, C, and D), past retrieval methods have focused on a single pair (C).
more » ... Here we present an Umkehr inversion method that uses measurements at all SZAs and all wavelength pairs. (Although, we caution direct comparison to other algorithms.) <br><br> Information content for a Melbourne, Australia (38° S, 145° E) Umkehr measurement case study from 28 January 1994, with SZA range similar to that designated in previous algorithms is shown. When comparing the typical single wavelength pair with designated SZAs to the raw measurements, the total degrees of freedom (independent pieces of information) increases from 3.1 to 3.4, with the majority of the information gain originating from Umkehr layers 2 + 3 and 4 (10–20 km and 25–30 km respectively). In addition to this, using all available wavelength pairs increases the total degrees of freedom to 5.2, with the most significant increases in Umkehr layers 2 + 3 to 7 and 9+ (10–40 km and 45–80 km). Investigating a case from 13 April 1970 where the measurements extend beyond the 90° SZA range gives an even further amount of information gain, with total degrees of freedom extending to 6.5. Similar increases are seen in the information content. Comparing the retrieved Melbourne Umkehr time-series with ozonesondes shows excellent agreement in layers 2 + 3 and 4 (10–20 km and 25–30 km) for both C and A + C + D-pairs. Retrievals in layers 5 and 6 (25–30 km and 30–35 km) consistently show lower ozone partial column compared to ozonesondes. This is likely due to and stray light effects that are not accounted for in the forward model, and under represented stratospheric aerosol.
doi:10.5194/amtd-7-8669-2014 fatcat:6zjhnuili5huxkn2oy42vgwm2i