An experimental investigation of effect of minimum quantity lubrication in machining 6082 aluminum alloy

R. YIGIT
2016 Kovové materiály  
In the recent years a lot has been done to avoid the cutting fluids from the production. Dry cutting and semi-dry cutting such as minimum quantity lubrication (MQL) have been favored by the industry. However, one of the main limitations in the application of MQL is that the full mechanism has not yet been fully understood. This paper presents the effects of MQL on the turning performance of aluminum alloy 6082 as compared to completely dry and wet machining in terms of tool wear, surface
more » ... ear, surface roughness and cutting forces. It was also seen from the results that the substantial reduction in tool wears resulted in enhanced tool life and surface finish. Furthermore, MQL provides environment friendliness (maintaining neat, clean and dry working area, avoiding inconvenience and health hazards due to heat, smoke, fumes, gases, etc., and preventing pollution of the surroundings), and improves the machinability characteristics. K e y w o r d s : machining, MQL, tool wear
doi:10.4149/km_2014_1_29 fatcat:ftxdtngiybfebibhmlqg2b6b4e