Photoacoustic-based thermal image formation and optimization using an evolutionary genetic algorithm

João Henrique Uliana, Diego Ronaldo Thomaz Sampaio, Antonio Adilton Oliveira Carneiro, Theo Zeferino Pavan
2018 Research on Biomedical Engineering  
For improved efficiency and security in heat application during hyperthermia, it is important to monitor tissue temperature during treatments. Photoacoustic (PA) pressure wave amplitude has a temperature dependence given by the Gruenesein parameter. Consequently, changes in PA signal amplitude carry information about temperature variation in tissue. Therefore, PA has been proposed as an imaging technique to monitor temperature during hyperthermia. However, no studies have compared the
more » ... e of different algorithms to generate PA-based thermal images. Methods: Here, four methods to estimate variations in PA signal amplitude for thermal image formation were investigated: peak-to-peak, integral of the modulus, autocorrelation of the maximum value, and energy of the signal. Changes in PA signal amplitude were evaluated using a 1-D window moving across the entire image. PA images were acquired for temperatures ranging from 36 o C to 41 o C using a phantom immersed in a temperature controlled thermal bath. Results: The results demonstrated that imaging processing parameters and methods involved in tracking variations in PA signal amplitude drastically affected the sensitivity and accuracy of thermal images formation. The sensitivity fluctuated more than 20% across the different methods and parameters used. After optimizing the parameters to generate the thermal images using an evolutionary genetic algorithm (GA), the percentage of pixels within the acceptable error was improved, in average, by 7.5%. Conclusion: Optimization of processing parameters using GA could increase the accuracy of measurement for this experimental setup and improve quality of PA-based thermal images.
doi:10.1590/2446-4740.00218 fatcat:s53bedmabjebxp4kk7qe3oyp54