Filters








130 Hits in 7.7 sec

Design and Simulation of FPGA Based Digital Controller for Single Phase Boost PFC Converter

Aishwarya B A, Radha R
2015 International Journal of Engineering Research and  
A model of 650W FPGA-controlled boost PFC converter with 98~120 V in the ac input and 390V in the dc output has been simulated in MATLB/SIMULINK using Xilinx System Generator(XSG) environment. I.  ...  This paper present a design of the digital controller for continuous conduction mode Boost converter with power factor correction (PFC) on Xilinx FPGA.  ...  Fig. 5 5 Fig. 5 Simulation circuit diagram in MATLAB/SIMULINK and Xilinx System Generator environment. Fig. 6 6 Fig. 6 Input current and input voltage at different loads.  ... 
doi:10.17577/ijertv4is041477 fatcat:z4ugwegdonhu3c4hpstijzd6xi

BLDC Motor-Driven Solar PV Array-Fed Water Pumping System Employing Zeta Converter

Rajan Kumar, Bhim Singh
2016 IEEE transactions on industry applications  
The hardware implementation is done for open loop control using FPGA controller of Xilinx Spartan 3AN and the results are demonstrated.  ...  The proposed system is simulated on MATLAB platform with closed loop control obtaining satisfactory results.  ...  Simulated result of the proposed model in MATLAB/SIMULINK is giving satisfactory results for closed loop control.  ... 
doi:10.1109/tia.2016.2522943 fatcat:gvahwug24vfyhdgqhrjpehhzzy

Hardware Implementation of Hybrid Wind-Solar Energy System for Pumping Water Based on Artificial Neural Network Controller

Ons ZARRAD, Mohamed Ali HAJJAJI, Mohamed Nejib MANSOURI
2019 Studies in Informatics and Control  
For this, the simulation and hardware implementation of the proposed algorithm are accomplished using MATLAB/SIMULINK and a Xilinx System Generator.  ...  The second contribution is represented by the optimization of the system respecting real-time constraints in order to increase the generating system performance.  ...  actually allows designing and simulating a system through the use of MATLAB/ SIMULINK and Xilinx library.  ... 
doi:10.24846/v28i1y201904 fatcat:hh5hsevwfbe6zff5m6naggg4du

Implementation of FPGA based DPWM-Digital PI Closed Loop Controller for Voltage Regulation

Prathap Joseph Anthony, T. S. Anandhi, T. S. Sivakumaran
2016 Indian Journal of Science and Technology  
The closed loop DPWM activated DC-DC buck converter is simulated using MODELSIM and tested in real time using Xilinx Spartan 3A DSP FPGA.  ...  Objectives: In this paper, a Field Programmable Gate Array (FPGA) based real time implementation of a closed loop controller for regulating the load voltage under line and load disturbances by generating  ...  The authors would like to thank the department of Electronics and Instrumentation Engineering, Annamalai University, Chidambaram, India for the facilities and assistance provided in the laboratory.  ... 
doi:10.17485/ijst/2016/v9i38/101940 fatcat:i56nlloroze2pbuglyncf3rgxq

High dynamic performance of a BLDC motor with a front end converter using an FPGA based controller for electric vehicle application

Praveen YADAV, Rajesh POOLA, Khaja NAJUMUDEEN
2016 Turkish Journal of Electrical Engineering and Computer Sciences  
The feasibility of the proposed dual loop control topology for the BLDC motor drive system is validated and verified with extensive dynamic simulation in MATLAB/SIMULINK and XSG environment.  ...  The operational characteristics of the proposed BLDC motor drive system for constant as well as step changes in dc link voltage of a front end converter controlled by a Xilinx System Generator (XSG) based  ...  Finally the performance of the system is evaluated in MATLAB/SIMULINK software integrated with the Xilinx system generator.  ... 
doi:10.3906/elk-1401-289 fatcat:cz73gu5xpjbovkgwhbikvvke6e

FPGA Implementation of a Three-Level Boost Converter-fed Seven-Level DC-Link Cascade H-Bridge inverter for Photovoltaic Applications

Nagaraja Sulake, Ashok Devarasetty Venkata, Sai Choppavarapu
2018 Electronics  
The proposed system has been modeled and simulated using MATLAB/SIMULINK software. Results are presented and discussed.  ...  The proposed TLBDCLCHB MLI system is obtained by integrating a three-level boost converter (TLBC) with a seven-level DC-link cascade H-bridge (DCLCHB) inverter.  ...  Simulation and Experimental Validation of the Proposed TLBDCLCHB Inverter System The simulation of the proposed single-phase seven-level TLBDCLCHB inverter system is analyzed using MATLAB Simulink and  ... 
doi:10.3390/electronics7110282 fatcat:bfxav2ypw5catnxjrsbsepbhza

A Comparison of Simulation and Hardware-in-the- Loop Alternatives for Digital Control of Power Converters

Alberto Sanchez, Angel de Castro, Javier Garrido
2012 IEEE Transactions on Industrial Informatics  
All of them allow simulation, and two methods also allow emulation -synthesizing the model of the converter to run the complete closed loop system in actual hardware.  ...  The alternative is to use pure digital models, generating a digital model of the power converter.  ...  PFC technique with a boost converter digital hardware (a computer, a microprocessor or an FPGA) to emulate all the closed loop system in hardware.  ... 
doi:10.1109/tii.2012.2192281 fatcat:tv2hup5hfzdftkq2jrdjnazlty

Design and Experimentation of FPGA-Based Soft-Switched Interleaved Boost Converter for Telecommunication System

Chitravalavan, Dr. R. Seyezhai
2016 Circuits and Systems  
The proposed converter is studied by developing the simulation module in MATLAB/SIMULINK.  ...  Simulation and experimentation results are verified with a prototype development of the proposed converter. The results indicate that the converter performance is enhanced with closed loop control.  ...  The ramp signals are generated with switching frequency of 30 kHz using up counter from the Xilinx blocks.  ... 
doi:10.4236/cs.2016.79233 fatcat:5zdl5bh4k5eq5eomwtuogb5azu

FPGA Implementation of PID Controller for the Stabilization of a DC-DC "Buck" Converter [chapter]

Eric William, Jesus Linares-Flores, Enrique Guzman-Ramirez, Hebertt Sira-Ramirez
2012 Frontiers in Advanced Control Systems  
Fig. 6 . 6 Simulink block with the inputs and outputs of the PSIM circuit. Fig. 7 . 7 Output voltage of buck converter in open-loop. cosimulation between Matlab/Simulink and Psim.  ...  The cosimulation provides a fast bidirectional link between the hardware description language (HDL) simulator, and Matlab/Simulink for direct hardware design verification Matlab (2008).  ... 
doi:10.5772/39083 fatcat:lv3livinj5gvpb3glxs75pxdza

A Critical Review- Photovoltaic Maximum Power Point Tracking Control System Using P&O Technique

A.A. CHANDANE
2016 Zenodo  
Maximum point tracking system,is used in photo voltaic system for the maximizing output for the PV array,irrespective of the temperature radiation and the environmental conditions or electrical load characteristics  ...  In some of the papers its been found that the implementation of perturbation and observation in conjunction of the incremental conductance is been used and its gaining popularity day by day. https://www.ijiert.org  ...  In this paper discussion on the boost converter also the transfer function of the boost converter has been given in a great detail.  ... 
doi:10.5281/zenodo.1462334 fatcat:6dfmgqvzobdszgfm4tdzajjohe

DESIGN AND ANALYSIS OF CONTROLLED SEPIC AND LLC CONVERTERS FOR PHOTOVOLTAIC SYSTEMS

Mohamed Fakhry, Mohamed Saber, Mohamed E. Eltantawi, Sahar S. Kaddah, Basem M. Badr
2020 International Journal of Engineering Applied Sciences and Technology  
MATLAB/SIMULINK is used to model and simulate the proposed PV systems, where the performance of the open loop and closed loop (PID/FLC) systems for the SEPIC and the LLC are analyzed with respect to solar  ...  The simulation results of the proposed PV systems show that the output voltage is controlled and stabled successfully to the required voltage for various loads/applications while the input power from the  ...  Hardware prototype was developed and simulated using MATLAB/SIMULINK platform.  ... 
doi:10.33564/ijeast.2020.v05i08.008 fatcat:n2mmyodk7ngudi77kkpxpgcxxy

Derivative-Free Direct Search Optimization Method for Enhancing Performance of Analytical Design Approach-Based Digital Controller for Switching Regulator

Abbas, Nazeer, Balas, Lin, Balas, Asad, Raza, Shehzad, Farooq, Gu
2019 Energies  
A system generator-based hardware software co-simulation is also performed to validate the simulation results.  ...  A switching-mode buck regulator working at 1 MHz in continuous conduction mode (CCM) is considered as a plant.  ...  Conflicts of Interest: The authors declare no conflict of interest.  ... 
doi:10.3390/en12112183 fatcat:3dv3aptfizhwled3vx3ay5zgby

Cardiac excitation modeling: HDL coder optimization towards FPGA stand-alone implementation

Norliza Othman, Farhanahani Mahmud, Abd Kadir Mahamad, M. Hairol Jabbar, Nur Atiqah Adon
2014 2014 IEEE International Conference on Control System, Computing and Engineering (ICCSCE 2014)  
from a designed MATLAB Simulink blocks of Luo-Rudy Phase I (LR-I) model towards FPGA hardware-implemented for numerical solutions of ordinary differential equations (ODEs) responsible in generating the  ...  The aim of this paper is to discuss the optimization of the hardware description language (HDL) design using fixedpoint optimization and speed optimization through a pipelining method.  ...  Whereas, automatic code generation lets designers to make changes in the system level model and produce an updated Hardware Description Language (HDL) in a short time.  ... 
doi:10.1109/iccsce.2014.7072771 dblp:conf/iccsce/OthmanMMJA14 fatcat:uem2xou6w5bcjc2cfh5hcpbrxi

Digital Control of Photovoltaic based Multilevel Converter for Improved Harmonic Performance

Akbar Ahmad, Paulson Samuel
2016 Indian Journal of Science and Technology  
The exemplification of mathematical analysis and hardware in loop results with Nexys 4 FPGA digital controller with Xilinx and MATLAB/Simulink for digital control modulation of Marx multilevel inverter  ...  The hardware results show the similarity with the simulated version with comparison with pre-existing topologies.  ...  It provides simulation, modeling and automatic code generation from MATLAB/Simulink and Xilinx interface.  ... 
doi:10.17485/ijst/2016/v9i44/101957 fatcat:evzgb7ikj5espcd5pigpmccd6m

Hardware-in-the-Loop and Digital Control Techniques Applied to Single-Phase PFC Converters

Paula Lamo, Angel de Castro, Alberto Sanchez, Gustavo A. Ruiz, Francisco J. Azcondo, Alberto Pigazo
2021 Electronics  
Hardware-in-the-loop (HIL) is a cost-effective technique that allows the power converter to be replaced by a real-time simulation model, avoiding building prototypes in the early stages for the development  ...  Power electronic converters for power factor correction (PFC) play a key role in single-phase electrical power systems, ensuring that the line current waveform complies with the applicable standards and  ...  In the case in which the simulation involves energy transfer (Figure 1b) , the system is called Power hardware-in-the-loop (PHIL) [33] .  ... 
doi:10.3390/electronics10131563 fatcat:abzzjusimvevxoqhbbyiw6dz2y
« Previous Showing results 1 — 15 out of 130 results