Filters








405 Hits in 11.7 sec

On the use of in-situ piezoelectric sensors for the manufacturing and structural health monitoring of polymer-matrix composites: A literature review

C. Tuloup, W. Harizi, Z. Aboura, Y. Meyer, K. Khellil, R. Lachat
2019 Composite structures  
(PMC) using in-situ piezoelectric sensors.  ...  This article aims to provide a general overview of what has been achieved recently in the scientific community on the manufacturing monitoring and structural health monitoring of polymer-matrix composites  ...  This technique needs the piezoelectric transducers to act in both active and passive modes in order to generate and receive US waves. These waves can be volume or plate (Lamb/guided) waves.  ... 
doi:10.1016/j.compstruct.2019.02.046 fatcat:dzhvtlw2fje3jkr7ir3l7bsvki

Embedded Non-destructive Evaluation for Structural Health Monitoring, Damage Detection, and Failure Prevention

V. Giurgiutiu
2005 The Shock and vibration digest  
We begin by reviewing the guided wave theory in plate, tube, and shell structures, with special attention to Lamb waves.  ...  The enabling element of embedded ultrasonic NDE is the piezoelectric wafer active sensor (PWAS).  ...  Lamb waves are guided waves traveling along thin plates, while Rayleigh waves are guided waves constraint to the surface.  ... 
doi:10.1177/0583102405052561 fatcat:idxknviphfejje45afbijhx7um

Damage Detection in Composite Plates by Using an Enhanced Time Reversal Method

Hoon Sohn, Hyun Woo Park, Kincho H. Law, Charles R. Farrar
2007 Journal of Aerospace Engineering  
This time reversibility of Lamb waves is violated when wave distortion due to wave scattering is caused by a defect along a direct wave path.  ...  A time reversal concept of modern acoustics has been adapted to guided-wave propagation to improve the detectability of local defects in composite structures.  ...  EXPERIMENTAL STUDY Experimental Test Setup The overall test configuration of this study is shown in Figure 6 A commercially available thin film with embedded piezoelectric (PZT) sensors is mounted  ... 
doi:10.1061/(asce)0893-1321(2007)20:3(141) fatcat:7maxxyt6izcnhnh3rjhoywhfqm

Toward Smart Aerospace Structures: Design of a Piezoelectric Sensor and Its Analog Interface for Flaw Detection

Hamza Boukabache, Christophe Escriba, Jean-Yves Fourniols
2014 Sensors  
Our work in this field focuses on the development and the system integration of millimetric piezoelectric sensors/ actuators to generate and measure specific guided waves.  ...  Finally, a novel joined time-frequency analysis based on a wavelet decomposition algorithm is used to extract relevant structures signatures.  ...  Many thanks are due to EADS-IW and the Airbus group who provided the aircraft specimens.  ... 
doi:10.3390/s141120543 pmid:25365457 pmcid:PMC4279499 fatcat:msl6rhqj2fg5zi75eaouwwpxea

Evaluation of Delamination in Concrete by IE Testing Using Multi-Channel Elastic Wave Data

Seong-Hoon Kee, Jin-Wook Lee, Ma. Doreen Candelaria
2019 Sensors  
The dominant wave modes were used to evaluate delamination defects in concrete.  ...  First, prototype equipment using an eight-channel linear sensor array was developed to perform elastic wave measurements on the surface of the concrete.  ...  First, it enables us to simultaneously extract two important wave modes (A0 and S1 ZGV Lamb wave mode).  ... 
doi:10.3390/s20010201 pmid:31905886 fatcat:4op73py7t5by7dnmth2dbviciy

A Methodological Review of Piezoelectric Based Acoustic Wave Generation and Detection Techniques for Structural Health Monitoring

Zhigang Sun, Bruno Rocha, Kuo-Ting Wu, Nezih Mrad
2013 International Journal of Aerospace Engineering  
This paper is set forth to review a variety of ingenious ways in which piezoelectric transducers are used in today's SHM technologies as a means of generation and/or detection of diagnostic acoustic waves  ...  Piezoelectric transducers have a long history of applications in nondestructive evaluation of material and structure integrity owing to their ability of transforming mechanical energy to electrical energy  ...  in a relatively thick structural component, in comparison to the thin-wall members usually used for experimentation with guided acoustic waves.  ... 
doi:10.1155/2013/928627 fatcat:vk7xlefy7jdb3iym6jnhy64eea

Structural Health Monitoring for Composite Materials [chapter]

Jian Cai, Lei Qiu, Shenfang Yuan, Lihua Shi, PeiPei Liu, Dong Liang
2012 Composites and Their Applications  
Lamb wave method Lamb waves, first theoretically predicted by Horace Lamb in 1917, are a kind of guided ultrasonic waves existing in thin-wall structures.  ...  Due to the multi-mode and dispersion characteristics, the propagation of Lamb waves is very complicated.  ... 
doi:10.5772/48215 fatcat:u6n2ey7ecncyjh6bc2r3kmylye

Disbond detection in adhesively bonded structures using piezoelectric wafer active sensors

Adrian Cuc, Victor Giurgiutiu, Tribikram Kundu
2004 Health Monitoring and Smart Nondestructive Evaluation of Structural and Biological Systems III  
The paper will present a study of the use of guided Lamb waves for disbond detection in adhesively bonded layered media using piezoelectric wafer active sensors (PWAS).  ...  For far-field detection, propagating Lamb waves will be used in pitch-catch and pulse-echo modes.  ...  These techniques are now being transitioned to embedded active sensor applications using PWAS technology ( Figure 1 ).  ... 
doi:10.1117/12.540358 fatcat:xg6p5xhe3rdk7ofn5uuqnb7sh4

Review of Guided-wave Structural Health Monitoring

A. Raghavan, C. E. S. Cesnik
2007 The Shock and vibration digest  
Next, we examine guided-wave theory, tracing its early history down to modern developments. Following this, we detail the efforts into models for guided-wave excitation by SHM transducers.  ...  The next topic in Section 6 is guided-wave SHM system development, and we explore various packaging ideas, integrated solutions and efforts to examine robustness to different service conditions.  ...  Lin et al. (2001) have developed the "SMART Layer" (as shown in Figure 11a ), which is a thin dielectric film with an embedded network of distributed piezoelectric actuators and sensors, and includes  ... 
doi:10.1177/0583102406075428 fatcat:n3x4vlyd3fahdk3wu6jyzqit3q

Piezoelectric Sensing Techniques in Structural Health Monitoring: A State-of-the-Art Review

Pengcheng Jiao, King-James I. Egbe, Yiwei Xie, Ali Matin Nazar, Amir H. Alavi
2020 Sensors  
We present the principle of the piezoelectric effect and the underlying mechanisms used by the piezoelectric sensing methods to detect the structural response.  ...  These techniques range from piezoelectric electromechanical impedance and ultrasonic Lamb wave methods to a class of cutting-edge self-powered sensing systems.  ...  The layer consists of a thin dielectric film embedded with an array of piezoelectric actuators/sensors intended to be surface-mounted on metallic structures or embedded inside composite structures.  ... 
doi:10.3390/s20133730 pmid:32635286 pmcid:PMC7374461 fatcat:2b3rfwz5tnfhbhxfylkl2egou4

Ultrasonic Guided-Waves Sensors and Integrated Structural Health Monitoring Systems for Impact Detection and Localization: A Review

Lorenzo Capineri, Andrea Bulletti
2021 Sensors  
This review article is focused on the analysis of the state of the art of sensors for guided ultrasonic waves for the detection and localization of impacts for structural health monitoring (SHM).  ...  The integration aspects of sensors for the creation of networks with autonomous nodes with the possibility of powering through energy harvesting devices and the embedded processing capacity is also studied  ...  This is a nondispersive mode and piezoelectric sensors/transducers can be designed to convert this wave type into voltage signals.  ... 
doi:10.3390/s21092929 pmid:33922056 fatcat:2vexoguzirenfbgghamz4vws5y

Time reversal active sensing for health monitoring of a composite plate

Hyun Woo Park, Hoon Sohn, Kincho H. Law, Charles R. Farrar
2007 Journal of Sound and Vibration  
A time reversal method has been adapted to guided-wave propagation to improve the detectability of local defects in composite plate structures.  ...  Specifically, wavelet-based signal processing techniques have been developed to enhance the time reversibility of Lamb wave in thin composite plates.  ...  A commercially available thin film with embedded piezoelectric (PZT) sensors is mounted on one surface of the composite plate as shown in Figure 8(b) [23].  ... 
doi:10.1016/j.jsv.2006.10.044 fatcat:mdpmn6vfdbg2jlrtuxol7ur75y

Piezoelectric Transducer-Based Structural Health Monitoring for Aircraft Applications

Xinlin Qing, Wenzhuo Li, Yishou Wang, Hu Sun
2019 Sensors  
Among the various types of transducers used for SHM, piezoelectric materials are widely used because they can be employed as either actuators or sensors due to their piezoelectric effect and vice versa  ...  State-of-the-art techniques for solving some practical issues, such as sensor network integration, scalability to large structures, reliability and effect of environmental conditions, robust damage detection  ...  Acknowledgments: The authors also would like to thank Jianjian Zhu, Xiaofeng Yang and other colleagues at Xiamen University and Beijing Aeronautical Science and Technology Research Institute of COMAC for  ... 
doi:10.3390/s19030545 fatcat:dwnrq54g4jdkxkbinjfvhhb25q

A Review of Vibration-based Structural Health Monitoring with Special Emphasis on Composite Materials

D. Montalvao
2006 The Shock and vibration digest  
According to Doebling et al. (1996**) , ideally, a robust damage detection scheme should be able to identify damage at a very early stage, locate the damage within the sensor resolution being used, provide  ...  some estimate for the damage extension or severity and to predict the remaining useful life of the structural component where damage has been identified.  ...  It was found that the three methods studied can be complementary because they can use the same sensors/actuators, which in this case were commercially available thin films with embedded PZT sensors.  ... 
doi:10.1177/0583102406065898 fatcat:cpo5laltkrdyngvekhxholoiaq

Propagation and scattering of guided waves in composite plates with defects

Bibi I. S. Murat, P. Fromme
2016 International Journal of Automotive and Mechanical Engineering  
From the 2D FE simulations of guided wave interaction with large delaminations, it was found that the mode converted S 0 mode was generated when the A 0 mode encountered the delamination, but that the  ...  Using 3D FE, it was also observed that there is little or no converted S 0 mode when the A 0 mode encounters delaminations located at a symmetric interface [80] .  ... 
doi:10.15282/ijame.13.3.2016.15.0305 fatcat:twsdnbiiuzhkvgydajkjhl5ncm
« Previous Showing results 1 — 15 out of 405 results