A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2020; you can also visit the original URL.
The file type is application/pdf.
Filters
Dual link fault diagnosis agreement
2004
Journal of Systems and Software
Preserved Fulltext
And on the other hand, the most fault diagnosis algorithms can detect and locate faulty components but few of them can make all fault free processors reach an agreement. ...
This study analyzes the messages received at the period of reaching agreement, and then, to detect and to locate the faulty links of the network. ...
Although, many tremendous fault diagnosis algorithms are available, few of them can make all fault-free processors reach an agreement. ...
doi:10.1016/s0164-1212(02)00153-x
fatcat:v2qlx3miizhq5kql7ej2j43apm
Page 8157 of Mathematical Reviews Vol. , Issue 2004j
[page]
2004
Mathematical Reviews
Preserved Fulltext
The Internet Archive has digitized a microfilm copy of this work. It may be possible to borrow a copy for reading.
This is often called fault identification in system diagnosis. This paper focuses on the identification of unreliable units within the Byzantine framework. ...
Most BA protocols require all the fault-free pro- cessors to reach a common agreement at the same round, called an immediate Byzantine agreement (IBA), whereas another type of BA protocol allows the fault-free ...
Simple current sensor fault‐tolerant control strategy for switched reluctance motors in high‐reliability applications
2021
IET electric power applications
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2021; you can also visit the original URL.
The file type is application/pdf.
Moreover, through the analysis of the detected currents by the phase current sensors and the dc-link sensor, a diagnostic scheme for current sensors failure is presented. ...
Motor drive can operate with satisfactory control performance even when all the phase current sensors are in fault conditions. ...
and reconstructed currents and (d) reconstructed excitation current of phase A Fault diagnosis and tolerant control under dual-current sensor failure: (a) dc-link current (A), (b) phase currents (A) and ...
doi:10.1049/elp2.12058
fatcat:ybbooohipngqjkijhwfhjwaeze
A Novel Dual Separate Paths (DSP) Algorithm Providing Fault-Tolerant Communication for Wireless Sensor Networks
2017
Sensors
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2019; you can also visit the original URL.
The file type is application/pdf.
Fault-tolerance in a WSN ensures that the WSN is available for use without any interruption when any link or node failure occurs in the network. ...
This paper proposes a novel path redundancy-based algorithm, called dual separate paths (DSP), that provides fault-tolerant communication with the improvement of the network traffic performance for WSN ...
[17] introduced a model-free fault detection and diagnosis system (FDDS) to be able to detect and isolate faults in CPSs characterized by a large number of sensors. ...
doi:10.3390/s17081699
pmid:28757544
pmcid:PMC5579733
fatcat:cjy3lxupr5fnnjkwys2jqj7fqy
Ecological Interface Design: Sensor Failure Diagnosis in Air Traffic Control
2016
IFAC-PapersOnLine
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2018; you can also visit the original URL.
The file type is application/pdf.
In this paper the Ecological Interface Design (EID) framework is explored to assist controllers in fault diagnosis using a prototype ecological interface (called the Solution Space Diagram) for tactical ...
We hypothesize that presenting these links will expedite fault diagnosis and monitor automation decisions to pending separation conflicts. ...
Furthermore, it is shown that improved fault diagnosis is more pronounced in unstructured, complex situations. ...
doi:10.1016/j.ifacol.2016.10.560
fatcat:ilogze2aejggnkkejg5a2njbqa
Central-Tapped Node Linked Modular Fault-Tolerance Topology for SRM Applications
2016
IEEE transactions on power electronics
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2017; you can also visit the original URL.
The file type is application/pdf.
The dc-link voltage is fixed to 48V. Two air switches are adopted to generate open-circuit and short-circuit faults. ...
in short-circuit fault diagnosis. ...
doi:10.1109/tpel.2015.2414664
fatcat:auf5hecrebh5fa6wzqzqgoh34a
Interactive Consistency on a Time-Triggered Real-Time Control Network
2006
IEEE Transactions on Industrial Informatics
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2017; you can also visit the original URL.
The file type is application/pdf.
This prototype system demonstrates that interactive consistency is successfully achieved in the presence of a number of faults. ...
In addition to guaranteeing a high level of reliability, these communication systems should facilitate the development of fault-tolerant applications. ...
This asymmetric fault-free stage generates agreement between nodes. ...
doi:10.1109/tii.2006.885189
fatcat:zyxmtc5cvffp7l5gdaal5iogra
A Learning-Based Service Function Chain Early Fault Diagnosis Mechanism Based on In-Band Network Telemetry
2022
IEICE transactions on information and systems
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2022; you can also visit the original URL.
The file type is application/pdf.
In this current paper, enabled by a novel detailed network debugging technology, In-band Network Telemetry (INT), we propose a learning based framework for early SFC fault prediction and diagnosis. ...
Finally, Support Vector Machine (SVM) is utilized as network fault classifier to predict possible SFC faults. ...
Table 1 1 Fault class label definition Link 1 fault Link 2 fault Switch 2 fault Class label 0
Table 2 2 Example of data set t Link 1 delay Link 2 delay Switch 2 delay end-to-end delay Link 1 fault Link ...
doi:10.1587/transinf.2021edp7138
fatcat:eicn7drewfdmdbkalxt2lrhbhu
Real Time Fault Diagnosis for Propulsion Systems
1991
IFAC Proceedings Volumes
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2018; you can also visit the original URL.
The file type is application/pdf.
Fault Mode Defection (FMD) Layer The ms/duals _ Yn,_=_,_,t- Y,_o_ (7) These residuals are generated by Inducing stuck valve faults In tile nonlinear dynamic simulation of the $SME. ...
The research reported Is grouped In two
general areas, sensor fault detection and Intelligent fault diagnosis. ...
doi:10.1016/s1474-6670(17)51189-1
fatcat:ncvid53uwfbg3lyqewkeyfjonm
GUARDS: a generic upgradable architecture for real-time dependable systems
1999
IEEE Transactions on Parallel and Distributed Systems
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2017; you can also visit the original URL.
The file type is application/pdf.
AbstractÐThe development and validation of fault-tolerant computers for critical real-time applications are currently both costly and time consuming. ...
The two dimensions of physical redundancy allow the definition of a wide variety of instances with different fault tolerance strategies. ...
During the next -cycle, fault diagnosis can thus be performed using A. ...
doi:10.1109/71.774908
fatcat:6fts7tmq5veilfhkejnm744b34
Diagnosis of clustered faults and wafer testing
1998
IEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2017; you can also visit the original URL.
The file type is application/pdf.
A probabilistic diagnosis algorithm is presented for constant degree structures. ...
Both the test time and the diagnosis time are invariant with respect to the number of dies on the wafer. ...
When faulty units cluster together, as a dual effect, fault-free units also clustered together. ...
doi:10.1109/43.681263
fatcat:xd274tnvljdpxbmbdcz2gyr5xy
DATASOCKET TECHNOLOGY AND ITS APPLICATION IN EQUIPMENT REMOTE CONDITION MONITORING AND FAULT DIAGNOSIS
2016
International Journal on Smart Sensing and Intelligent Systems
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2017; you can also visit the original URL.
The file type is application/pdf.
By developing a set of equipment remote status monitoring and fault diagnosis system, the paper has tried to verify that the use of this technology can monitor real-time data and fault diagnosis. ...
Thus, the paper proposed Virtual Instrument technology based on DataSocket and its application in equipment remote condition monitoring and fault diagnosis. ...
Remote Fault Diagnosis Client Remote fault diagnosis client provides human-computer window for monitoring and diagnosis. ...
doi:10.21307/ijssis-2017-880
fatcat:v5jg5lu6jfcp5aaeatrvkq5z4e
Network fault diagnosis and rectification Suggestions for 300MW unit under I/A Series system
2019
E3S Web of Conferences
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2019; you can also visit the original URL.
The file type is application/pdf.
Through in-depth fault analysis, a feasible network optimization method is proposed to provide reference for network fault diagnosis and treatment, so as to ensure the safe and stable operation of the ...
The reason why IEEE 802.1w protocol is formulated is that although IEEE 802.1d protocol solves the problem of endless circulation caused by link closure, the convergence process of spanning tree still ...
doi:10.1051/e3sconf/201913601003
fatcat:jnfki7p2ozbfhp4rojd4rhp5qy
Industrial IoT based condition monitoring for wind energy conversion system
2020
CSEE Journal of Power and Energy Systems
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2022; you can also visit the original URL.
The file type is application/pdf.
Index Terms-Asset management, condition monitoring, fault diagnosis, industrial internet of things (IoT), wind energy conversion system.
I. ...
Faults, such as open and short circuit faults of switching devices and DC-link capacitors interrupt the continuity of the power flow. ...
doi:10.17775/cseejpes.2020.00680
fatcat:tn5iek4bavdqboyvnhu7p24ecy
Enhancing Fault Detection in Time Sensitive Networks using Machine Learning
2020
Zenodo
Preserved Fulltext
A copy of this work was available on the public web and has been preserved in the Wayback Machine. The capture dates from 2022; you can also visit the original URL.
The file type is application/pdf.
ACKNOWLEDGMENT The reported research is funded by the EU Horizon 2020 research and innovation programme under the Marie Skłodowska-Curie grant agreement No. 764785, FORA-Fog Computing for Robotics and ...
Such demands on the dual requirements of high bandwidth for multimedia data and deterministic, fault-tolerant delivery of safety-critical data can only be supported by a networking technology such as TSN ...
The fault model describes the faults on each link that can result in packet losses. ...
doi:10.5281/zenodo.5851248
fatcat:5isjkftne5akzjusscms22gxq4
« Previous
Showing results 1 — 15 out of 5,255 results