Filters








20 Hits in 11.5 sec

2.4 GHz BLE Receiver with Power-Efficient Quadrature RF-to-Baseband-Current-Reuse Architecture for Low-Power IoT Applications

Beomyu Park, Kuduck Kwon
2021 IEEE Access  
In this paper, a 2.4 GHz Bluetooth low energy receiver employing a power-efficient quadrature RF-to-baseband-current-reuse architecture is presented for low-power low-voltage internet of things applications  ...  The proposed quadrature RF-to-baseband-current-reuse RF front-end consists of a lownoise transconductance amplifier, an active-type polyphase filter-based quadrature generator, transimpedance amplifiers  ...  To this end, in this study, a 2.4 GHz BLE receiver with a power-efficient quadrature RF-to-BB-CR architecture was developed to be used in low-power IoT applications.  ... 
doi:10.1109/access.2021.3074650 fatcat:5gxzx6ye75fbfgsa3xw2hphjs4

Design Considerations for a Sub-mW Receiver Front-End for Internet-of-Things

Ehsan Kargaran, Danilo Manstretta, Rinaldo Castello
2021 IEEE Open Journal of Solid-State Circuits  
Low-power design techniques for LNA, frequency generation blocks and baseband amplifiers are presented. As a case study, an efficient low-IF RX front-end for IoT is described in detail.  ...  INDEX TERMS Ultra low-power (ULP), current reuse, gm-boosting, complex filter, IoT, ultra-low-voltage (ULV).  ...  Finally, a 2.4 GHz Low-IF RX front-end suitable for ULP IoT applications was reported as a case study to compare with other state-of-the-art ULP receivers using the two most common FoMs.  ... 
doi:10.1109/ojsscs.2021.3110461 fatcat:5ut5ta2ucne63p32n63wnt555e

Radio Systems and Computing at the Edge for IoT Sensor Nodes [chapter]

Malcolm H. Smith
2021 Smart Manufacturing - When Artificial Intelligence Meets the Internet of Things  
Many Internet of Things (IoT) applications use wireless links to communicate data back. Wireless system performance limits data rates.  ...  Generally cheap and power efficient radio front ends will not support high data rates which will mean that more computing will need to move to the edge.  ...  The FR1 spectrum is now also broken into low-band and mid-band in most discussions. Low-band spectrum starts at 410 MHz and includes the current cellular spectrum up to the 2.4 GHz ISM band.  ... 
doi:10.5772/intechopen.92987 fatcat:noal6kk7f5cuvimgz4gcy564sm

2021 Index IEEE Journal of Solid-State Circuits Vol. 56

2021 IEEE Journal of Solid-State Circuits  
Departments and other items may also be covered if they have been judged to have archival value. The Author Index contains the primary entry for each item, listed under the first author's name.  ...  ., +, JSSC June 2021 1697-1710 2.4-GHz Highly Selective IoT Receiver Front End With Power Optimized LNTA, Frequency Divider, and Baseband Analog FIR Filter.  ...  IoT Receiver Front End With Power Optimized LNTA, Frequency Divider, and Baseband Analog FIR Filter.  ... 
doi:10.1109/jssc.2021.3137574 fatcat:nfo3y7i5kncsng36fvi5g5hdre

A 0.7-V Sub-mW Type-II Phase-Tracking Bluetooth Low Energy Receiver in 28-nm CMOS

Suoping Hu, Peng Chen, Philip Quinlan, Robert Bogdan Staszewski
2021 IEEE Transactions on Circuits and Systems Part 1: Regular Papers  
We present an architecture of a Bluetooth low energy (BLE)-compliant receiver which, for the first time ever, breaks the 1 mW barrier of power consumption.  ...  RXs, current-reuse, ultra-low power (ULP), ultra-low voltage (ULV).  ...  ACKNOWLEDGMENT The authors would like to thank TSMC University Shuttle for the chip fabrication, Dr.  ... 
doi:10.1109/tcsi.2021.3070782 fatcat:qljebd5fsjez5ipc5hl4mdmyiy

Backscatter Communications

Ricardo Torres, Ricardo Correia, Nuno Carvalho, Spyridon Nektarios Daskalakis, George Goussetis, Yuan Ding, Apostolos Georgiadis, Aline Eid, Jimmy Hester, Manos M. Tentzeris
2021 IEEE Journal of Microwaves  
His current research interests include wireless power transfer, energy harvesting, wireless passive sensors for space applications, and low power communications.  ...  The low bit rate results in very low power consumption (current RFID tags can have sensitivities of less than −20 dBm) [33] , which is particularly suitable for sensing applications that involve a simple  ...  This article has been accepted for inclusion in a future issue of this journal. Content is final as presented, with the exception of pagination.  ... 
doi:10.1109/jmw.2021.3110058 fatcat:slvvfatbcngulbrr2tojzudjwm

A Type-II Phase-Tracking Receiver

Suoping Hu, Jianglin Du, Peng Chen, Hieu Minh Nguyen, Philip Quinlan, Teerachot Siriburanon, Robert Bogdan Staszewski
2020 IEEE Journal of Solid-State Circuits  
We present a new analog-to-digital converter (ADC)-based architecture of a phase-tracking receiver (PT-RX) optimized for ultra-low-power (ULP) and ultra-low-voltage (ULV) operations for the Internet of  ...  (SAR)-analog-to-digital converter (ADC), ultra-low power (ULP), ultra-low voltage (ULV).  ...  Hsieh-Hung Hsieh (TSMC) for help with the tape out, Viet Nguyen for technical discussions, Erik Staszewski for help with PCBs, Sunisa Staszewski for help with lab assistance, and the Microelectronic Circuits  ... 
doi:10.1109/jssc.2020.3005797 fatcat:gwq6dvljrbc5dnaeqhezc2mixq

Technologies for ABs

Alessandro Vizzarri, Mazzenga Franco, Giuliano Romeo, Vegni Anna Maria
2022 Zenodo  
), which are expected to be of interest for improving capabilities of the Adaptable Communication System (ACS).  ...  In the document a set of candidate communication technologies have been investigated as potential ones for railway applications.  ...  by dynamic power management active maintenance of receiver signal strength (for efficient connections) coexistence with other wireless devices with 2.4 GHz frequency range and present in the same area  ... 
doi:10.5281/zenodo.6288927 fatcat:zjth5wswjvge5plvjrhpqutpde

Software Defined Radio Platforms for Wireless Technologies

Dereje M. Molla, Hakim Badis, Laurent George, Marion Berbineau
2022 IEEE Access  
Traditional RF transceivers are designed and implemented on a radio chip or an embedded module in a System-on-a-Chip (SoC), ensuring small size, high performance, low power consumption, and cost.  ...  To support a wireless standard, a wireless transceiver should be equipped with a Radio Frequency (RF) transceiver.  ...  Among these standards are IEEE 802.15.4 and Bluetooth Low Energy (BLE), which are developed for networks with low power consumption, low deployment cost and less com-plexity.  ... 
doi:10.1109/access.2022.3154364 fatcat:z7czemg6qjevblveyr7hiaodve

2019 Index IEEE Journal of Solid-State Circuits Vol. 54

2019 IEEE Journal of Solid-State Circuits  
., +, JSSC May 2019 1339-1350 Design and Analysis of a DCO-Based Phase-Tracking RF Receiver for IoT Applications.  ...  ., +, JSSC Nov. 2019 3180-3190 Design and Analysis of a DCO-Based Phase-Tracking RF Receiver for IoT Applications.  ... 
doi:10.1109/jssc.2019.2956675 fatcat:laiuae7dtragjijttgfatsldmu

D3.1 Communication of IoT Devices

Efstathios Katranaras, Guillaume Vivier, Ignacio Garcia Zuazola, Jaime Ruiz Alonso, Ignacio Benito Frontelo, Ahmad Nimr, Roberto Bomfin, Ivo Bizon Franco de Almeida, Albert Marín-Bernad, David Gomez-Barquero, Cristina Avellan, José Luis Cárcel Cerver (+8 others)
2021 Zenodo  
This document describes how iNGENIOUS plans to evolve devices and communication solutions to support Next-Generation Internet of Things (NG-IoT) scenarios.  ...  , which are also mapped to the use cases of iNGENIOUS.  ...  The main contributors to achieve the expected cost reductions for the individual complexity reduction techniques are included in Table 13 for both RF and baseband blocks.  ... 
doi:10.5281/zenodo.4890976 fatcat:cqxyf76dtvgbhl4rh774pwubnq

Low Power Wide Area Network, Cognitive Radio and the Internet of Things: Potentials for Integration

Adeiza J. Onumanyi, Adnan M. Abu-Mahfouz, Gerhard P. Hancke
2020 Sensors  
These application areas typically comprise end nodes and gateways that are often interconnected by low power wide area network (LPWAN) technologies, which provide low power consumption rates to elongate  ...  Consequently, in this article, we survey the potentials of integrating CR in LPWAN for IoT-based applications.  ...  The 802.15.4 k option is designed for low energy critical infrastructure monitoring (LECIM) applications intended to operate in the ISM bands (sub-GHz and 2.4 GHz bands) [44] .  ... 
doi:10.3390/s20236837 pmid:33265899 fatcat:wnfdoxc7afdc7bqk3b4apmllfi

Ultra Low Power Wake-Up Radios: A Hardware and Networking Survey

Rajeev Piyare, Amy L. Murphy, Csaba Kiraly, Pietro Tosato, Davide Brunelli
2017 IEEE Communications Surveys and Tutorials  
This wake-up receiver technology represents 11 the ultimate frontier in low power radio communication.  ...  The most important challenge is to reduce power 5 consumption when receivers are idle, the so called idle-listening 6 cost.  ...  Cheng, "A 4.5 µW 2.4 GHz 3429 wake-up receiver based on complementary current-reuse RF detec-3430 tor," in Proc. IEEE Int. Symp. Circuits Syst.  ... 
doi:10.1109/comst.2017.2728092 fatcat:v7uonj6q6jev7lhefifvgph6vq

2021 Index IEEE Transactions on Microwave Theory and Techniques Vol. 69

2021 IEEE transactions on microwave theory and techniques  
Departments and other items may also be covered if they have been judged to have archival value. The Author Index contains the primary entry for each item, listed under the first author's name.  ...  Dai, J.Y., +, TMTT March 2021 1493-1510 Radio receivers 2.4-GHz Bluetooth Low Energy Receiver Employing New Quadrature Low-Noise Amplifier for Low-Power Low-Voltage IoT Applications.  ...  Ye, C., +, TMTT May 2021 2629-2641 Bluetooth 2.4-GHz Bluetooth Low Energy Receiver Employing New Quadrature Low-Noise Amplifier for Low-Power Low-Voltage IoT Applications.  ... 
doi:10.1109/tmtt.2022.3156771 fatcat:7iov55dzdnbprgd42epirpfaia

A Survey on 5G Networks for the Internet of Things: Communication Technologies and Challenges

Godfrey Anuga Akpakwu, Bruno J. Silva, Gerhard P. Hancke, Adnan M. Abu-Mahfouz
2018 IEEE Access  
The challenges and open research directions pertinent to the deployment of massive to critical IoT applications are also presented in coming up with an efficient context-aware congestion control mechanism  ...  More recent cellular standards like long-term evolution (LTE) have been introduced for mobile devices but are not well suited for low-power and low data rate devices such as the IoT devices.  ...  regulations for the 2.4 GHz band.  ... 
doi:10.1109/access.2017.2779844 fatcat:dfnk4oe2ifhqrnbn3gk6td64wy
« Previous Showing results 1 — 15 out of 20 results